How to Clean a Steam Mop [7+ Best Step ]

If you want to clean the floor without the aid of aggressive chemicals, you need to get a steam mop. It is powered by electricity, which heats the water contained in a ship. Once the water is heated to the right degree, steam is produced which eliminates dirt and grease. It saves you time and effort that would otherwise be needed to clean the floor. You can use the mop on hard floors such as stone, ceramic, marble and hardwood floors. It is important to clean the steam mop well after use. This will not only maintain its efficiency, but will also prolong its life.

Step 1: unplug the machine

Remove the cable from the power outlet before cleaning. If the machine has been in use, the mop pad and the lower parts will be hot during machine operation. Wait about 15 minutes for the machine to cool down completely.

Step 2: empty the tank after use

Always empty the tank after each use. There is a greater risk of mold or corrosion developing when you leave water in the tank.

Step 3: soak and wash dirty bearings

The steam cleaner is supplied with replacement mop pads. However, mop pads can be washed after use. This will help you stretch the bearings longer. Remove the used cloths. Soak soiled clothes after use with a normal laundry detergent and a spoonful of baking soda. Wait about 15 minutes for the cleaner to get dirty. Wash thoroughly and rinse with plenty of water. You should aim to remove all traces of soap. Hang the pads outside to air dry them. Make sure they dry completely before storing it. Alternatively, you can machine wash with hot water and tumble dry.

Step 4: clean the tank

Moisten a soft cloth with warm water. Thoroughly clean the inside of the tank. Make sure you reach all areas. Also wipe the outside with a damp cloth. Once you notice that the cloth is dirty, it is best to change it and use another cloth to complete the job. Set the tank aside in a safe place.

Step 5: Clean the surfaces of the Steam mop

Use a soft, damp cloth to clean the surface of the steamer. Make sure to clean all over the surface. Several cloths may be required to do the job. Collect all used cloths when you're done. You can machine wash them and tumble dry them.

Step 6: connect the tank

Install the clean tank into the steamer. Do not fill it with water. It is best to fill the tank when it is ready for use.

Step 7 - Store

Once cleaned and fully assembled, store the machine in an upright position. Make sure the storage area is dry and free of dust.

Extra tips

Never use cleaning products with a broom, as they could damage the equipment. Do not use bleach to clean mop pads, as this may weaken the material. Always use distilled or demineralized water for steam cleaning. This has no minerals and deposits and will improve your machine's performance.